A Study on the High-Efficiency Cutting of Austenite Stainless Steel Using HfN type Coated Tool
-
- Kato Hideharu
- Kanazawa Institute of Technology
-
- Shintani Kazuhiro
- Kanazawa Institute of Technology
-
- Nakamura Muneki
- Kanazawa Institute of Technology
-
- Shimomura Ryousuke
- Kanazawa Institute of Technology
-
- Sugita Hiroaki
- OSG Corporation
Bibliographic Information
- Other Title
-
- HfN系コーテッド工具を用いたオーステナイトステンレス鋼の高能率加工に関する研究
Abstract
In this research, the (Ti,Hf) N coated tool which is excellent in heat resistance is developed, and the cutting performance is investigated in high-speed machining of stainless steel which has the low characteristic of thermal conductivity. In wet continuous turning, the long life was shown on the high-speed conditions of cutting speed 4 m/s. Moreover, while a development tool has the uniform form of a cutting edge, most adhesion is not observed. Machined surface roughness was maintained to cutting length of 16km below at the surface roughness standard of 5μmRz. It showed clearly to show sufficient wear resistance also in milling operation.
Journal
-
- Proceedings of JSPE Semestrial Meeting
-
Proceedings of JSPE Semestrial Meeting 2008S (0), 247-248, 2008
The Japan Society for Precision Engineering
- Tweet
Keywords
Details 詳細情報について
-
- CRID
- 1390001205653431680
-
- NII Article ID
- 130005028991
-
- Data Source
-
- JaLC
- CiNii Articles
-
- Abstract License Flag
- Disallowed