ショットピーニング処理された超硬合金金型の表面性状の特徴と冷間リング圧縮における潤滑特性  [in Japanese] Characteristics of Surface Profile of Cemented Tungsten Carbide Dies after Shot Peening and Their Lubrication Performance in Cold Ring Compression  [in Japanese]

Access this Article

Search this Article

Author(s)

Abstract

The characteristics of the surface profile of cemented tungsten carbide dies after either shot peening (SP) orconventional mechanical polishing (MP) surfaces were investigated with a surface roughness tester. The relationshipbetween arithmetic and ten-point mean roughness was almost the same in the MP and SP dies. The mean period of thesurface roughness profile of the SP die was approximately 1/3 times shorter that of the MP die. The distribution of thepeaks and valleys of the surface profile was symmetric in the SP die, whereas it was skewed toward the peaks in the MPdie. The lubrication performance of the MP and SP dies in cold forging of a titanium workpiece was measured by thering compression test. The SP die with a mirror surface reduced the friction at a high reduction in height range becausethe die holds liquid lubricant in the micro valleys on its surface during the ring compression test.

Journal

  • Journal of the Japan Society for Technology of Plasticity

    Journal of the Japan Society for Technology of Plasticity 56(656), 793-797, 2015

    The Japan Society for Technology of Plasticity

Codes

  • NII Article ID (NAID)
    130005099039
  • NII NACSIS-CAT ID (NCID)
    AN00135062
  • Text Lang
    JPN
  • ISSN
    0038-1586
  • NDL Article ID
    026764831
  • NDL Call No.
    Z17-218
  • Data Source
    NDL  J-STAGE 
Page Top