Fabrication of Bacteriorhodopsin (bR) Thin Films by Wire-Bar Coating Technique and Evaluation of Transient Photocurrent Response in Its bR Photocells
-
- YAMADA Toshiki
- National Institute of Information and Communications Technology
-
- HARUYAMA Yoshihiro
- National Institute of Information and Communications Technology
-
- KASAI Katsuyuki
- National Institute of Information and Communications Technology
-
- KAJI Takahiro
- National Institute of Information and Communications Technology
-
- TOMINARI Yukihiro
- National Institute of Information and Communications Technology
-
- TANAKA Shukichi
- National Institute of Information and Communications Technology
-
- OTOMO Akira
- National Institute of Information and Communications Technology
抄録
<p>We prepared a bR thin film by the wire-bar coating technique, and investigated the transient photo-current characteristics of the bR photocell. The transient photo-current signal of bR photocells prepared by the wire-bar coating technique and the dip coating technique was compared. An almost identical transient photo-current signal intensity was obtained both for the wire-bar coating technique and dip coating technique, while the thickness of bR thin film prepared by the wire-bar coating technique is slightly thinner than that prepared by the dip-coating technique. Transparent conductive oxide dependence of the transient photo-current signal is almost the same dependence for the bR photocells with a bR thin film prepared by both techniques. Application of the wire-bar coating technique is significant from the viewpoints of the bR's sample consumption as well as simplicity of sample preparation.</p>
収録刊行物
-
- IEICE Transactions on Electronics
-
IEICE Transactions on Electronics E100.C (2), 133-136, 2017
一般社団法人 電子情報通信学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679355589376
-
- NII論文ID
- 130005306552
-
- ISSN
- 17451353
- 09168524
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可
