ポリプロピレン－銅メッシュ複合材料の塑性変形過程における不均一変形の評価

DOI Web Site Web Site 参考文献11件

書誌事項

タイトル別名
  • Evaluation of Nonuniform Deformation during Plastic Deformation of Polypropylene-Cu Mesh Composite
  • ポリプロピレン-ドウ メッシュ フクゴウ ザイリョウ ノ ソセイ ヘンケイ カテイ ニ オケル フキンイツ ヘンケイ ノ ヒョウカ

この論文をさがす

抄録

<p>To improve the plastic instability of a thermoplastic polymer composite under cold forming, a copper mesh was filled into the polypropylene (PP). PP-Cu mesh composite plate specimens with the Cu mesh inclined in various directions were formed by the compression molding of the PP pellet and Cu mesh. First, the tensile behavior of Cu meshes with the angles of 0/90°, 15/75°, 30/60° and 45° to the tensile direction was examined. The maximum stress decreased gradually with increasing Cu mesh angle to the tensile direction because the Cu wires rotated in the tensile direction. The anisotropic response was also confirmed for the PP-Cu mesh composite, and the anisotropy was emphasized for composites with the higher volume fractions of the Cu mesh. The decrease in the nominal stress, which is often seen in the tensile deformation of the thermoplastic polymer, almost disappeared for the composite specimen with the Cu mesh at the angle of 45° to the tensile direction. Also, the deformation concentration in the specimen was effectively suppressed by reducing the deformation resistance in the early stage of deformation and by increasing the strain hardening after yielding.</p>

収録刊行物

  • 塑性と加工

    塑性と加工 58 (673), 145-150, 2017

    一般社団法人 日本塑性加工学会

参考文献 (11)*注記

もっと見る

関連プロジェクト

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ