冷間据込み鍛造におけるねじりモーション付加による軸圧縮荷重の低減  [in Japanese] Reduction of Axial Forging Load in Cold Upsetting with Torsion Die Motion  [in Japanese]

Access this Article

Author(s)

Abstract

<p>To reduce axial forming load in upsetting process, upsetting process with cyclic torsion die motion was proposed. In the proposed upsetting process, cyclic torsion of torsional moment was simultaneously superposed with axial forming load during upsetting process. In this study, a cylindrical workpiece was twisted around the z-axis with an alternating amplitude angle of π/8 rad (22.5°) and a maximum rate of 0.05 rad/s (0.5 rpm) during upsetting with an axial compression speed of 0.1 mm/s. The maximum torsion frequency was 0.03 Hz. It was found that the axial forming load of the workpiece was reduced by approximately 5-40% in the forming conditions where torsion angle/axial stroke were larger than approximately 0.26 rad/mm.</p>

Journal

  • The Proceedings of Mechanical Engineering Congress, Japan

    The Proceedings of Mechanical Engineering Congress, Japan 2016(0), G0400103, 2016

    The Japan Society of Mechanical Engineers

Codes

Page Top