Study on Butt Weld Joint of Thick Plate Superconducting Coil Structure to Reduce Welding Residual Deformation
-
- NISHIMURA Arata
- National Institute for Fusion Science
この論文をさがす
抄録
<p>In a large fusion experimental device, the magnetic field in the coil is rather high to create higher magnetic field at the plasma center, and the coil current is very large resulting in generation of huge electromagnetic force. To sustain such huge electromagnetic force, thick section components are required for the coil structure of which material is generally an austenitic stainless steel to avoid magnetization. On the process of the welding design,the welding residual deformation must be taken into account to keep the position of the current center of the coil and to avoid the degradation of the superconducting conductor by the excessive welding residual strain. In this paper, a partial welding which was used for the LHD construction will be focused and the image of the conceptual welding design of ITER TF coil butt joints will be discussed for an example of the fusion application.</p>
収録刊行物
-
- Plasma and Fusion Research
-
Plasma and Fusion Research 14 (0), 3405062-3405062, 2019-04-10
一般社団法人 プラズマ・核融合学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390564238093026304
-
- NII論文ID
- 130007652192
-
- NII書誌ID
- AA12346675
-
- ISSN
- 18806821
-
- HANDLE
- 10655/00012988
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- IRDB
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可