バウシンガー効果活用による自動車部品の寸法精度変動低減技術の開発

DOI Web Site Web Site 被引用文献5件 参考文献8件

書誌事項

タイトル別名
  • Development of Forming Technology to Reduce Dimensional Scattering of Automotive Parts with Cambers by Using Bauschinger Effect
  • バウシンガー コウカ カツヨウ ニ ヨル ジドウシャ ブヒン ノ スンポウ セイド ヘンドウ テイゲン ギジュツ ノ カイハツ

この論文をさがす

抄録

<p>Dimensional scattering is a severe problem in press forming of ultrahigh-strength steels (UHSS), because of material strength scattering in mass production. In this study, camber back which occurs in longitudinally curved parts was focused on and a new forming method whereby dimensional scattering of camber back can be suppressed by the Bauschinger effect was developed. The new method consists of two processes. In the 1st process, a blank is formed to with a small radius of curvature compared with the 2nd-process radius of curvature. In the 2nd process, the 1st-formed part is formed to a large radius of curvature compared with the 1st-process radius of curvature. Then the Bauschinger effect works to decrease the amount of camber back. The new method was applied to a hat-shaped model of 590, 980, and 1180 MPagrade steels, where the radius of curvature in the longitudinal direction was 1600 mm. The experimental results showed that the difference in the amount of camber back between 590 MPa and 1180 MPa steels formed by the developed method decreased 95 % compared with the case of the conventional method.</p>

収録刊行物

  • 塑性と加工

    塑性と加工 60 (701), 155-160, 2019

    一般社団法人 日本塑性加工学会

被引用文献 (5)*注記

もっと見る

参考文献 (8)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ