Development of In-process Measuring System for Turning Process Using Acoustic Emission Method

• NINOMIYA Keiichi

  Polytechnic University

• MATUMOTO Yasunori

  Gifu Polytechnic Center

• KOGA Toshihiko

  Polytechnic University

• WADA Masaki

  Polytechnic University

書誌事項

タイトル別名

• (1st Report, Experimental Study on Elucidation of Mechanism of Cutting Phenomena)

抄録

The purpose of this research is to develop a system that can monitor the condition of the cutting process and keep it always in a normal or optimum state, in which the acoustic emission method is used for monitoring. In realizing the development of such a system, it is fundamental and important to evaluate the source of AE during cutting, that is, the cutting phenomenon qualitatively and quantitatively. In this report, after constructing an experimental system composed of AE measurement, cutting force measurement, and high speed camera, we examine the mechanism of cutting phenomenon from each basic data and discuss the findings obtained from the results. Simultaneously, the correspondence between experimental results and cutting simulation is also evaluated.

収録刊行物

• 設計工学

  設計工学 54 (10), 669-680, 2019

  公益社団法人 日本設計工学会

キーワード

• in-process measurement
• turning processes
• cutting phenomena
• acoustic emission
• finite element method

詳細情報

• CRID: 1390001277365907456
• NII論文ID: 130007724240
• DOI: 10.14953/jjsde.2019.2858
• ISSN: 21889023
• ISSN: 09192948
• 本文言語コード: en
• データソース種別:
  • JaLC
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可