EVALUATION OF SOURCE TERMS OF FISSION PRODUCTS IN GASEOUS EFFLUENTS AND RECOMMENDATIONS FOR EFFLUENT MONITORING OF NUCLEAR POWER PLANTS
-
- Zhu Zhaowen
- Nuclear and Radiation Safety Center, MEP
-
- Jiang Jing
- Nuclear and Radiation Safety Center, MEP
-
- Fang Lan
- Nuclear and Radiation Safety Center, MEP Third Qin-shan Nuclear Power Co., Ltd.
-
- Xu Chunyan
- Nuclear and Radiation Safety Center, MEP
-
- Liu Xinhua
- Nuclear and Radiation Safety Center, MEP
-
- Xie Feng
- Institute of Nuclear and New Energy Technology, Collaborative Innovation Center of Advanced Nuclear Energy Technology Key Laboratory of Advanced Reactor Engineering and Safety of Ministry of Education, Tsinghua University
-
- Lou Mengqi
- Institute of Nuclear and New Energy Technology, Collaborative Innovation Center of Advanced Nuclear Energy Technology Key Laboratory of Advanced Reactor Engineering and Safety of Ministry of Education, Tsinghua University
抄録
The source terms of fission products in the airborne effluents of the CPR1000 and HPR1000 (Hualong One) nuclear power plants (NPPs) in China were estimated for cycles without fuel failure. We used both the operational data for the primary coolants of domestic and foreign NPPs as well as the latest research on reactor source terms for this purpose. The results indicated that the activity concentrations of fission product nuclides in the gaseous effluents were two orders of magnitude lower than the detection limit of laboratory instruments. After comparing the domestic and foreign regulations on gaseous effluent monitoring of NPPs and reviewing the domestic gaseous effluent monitoring practices, recommendations on gaseous effluent monitoring were offered in this paper. This study could provide a technical basis for gaseous effluent management for NPPs and help revise the relevant Chinese regulations and standards in the future.
収録刊行物
-
- Proceedings of the ... International Conference on Nuclear Engineering. Book of abstracts : ICONE
-
Proceedings of the ... International Conference on Nuclear Engineering. Book of abstracts : ICONE 2019.27 (0), 1196-, 2019
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390846609787678976
-
- NII論文ID
- 130007773392
-
- ISSN
- 24242934
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可