書誌事項
- タイトル別名
-
- Improvement of zero adjustment error compensation in square layout four-point method by introducing angle sensor
抄録
<p>Square layout four-point method with angle correction has been proposed as an on-machine profile measurement method of machined flat surfaces. In this method, it is possible to measure the planar shape without the influence of translational error, pitching, and rolling of a stage. However, a zero-adjustment error, which is a deviation of the origin height of the four displacement sensors, causes a large form error of twist shape when the planar shape is reconstructed. To solve this problem, a back calculation method of the zero-adjustment error was proposed: which calculate zero-adjustment error from the difference in the error cumulative amount of two different calculation paths for a square measurement region, the raster scanning path and the diagonal path. To improve the calculation accuracy of zero-adjustment error, the authors have proposed to apply two-point method with angle correction to the diagonal direction by measuring the posture change of the stage unit with the angle sensor newly added in the diagonal direction. Monte Carlo simulations of the square layout four-point method and back calculation of zero-adjustment error were carried out. As a result, it was confirmed that the proposed method is effective to improve correction accuracy of the zero-adjustment error.</p>
収録刊行物
-
- 日本機械学会九州支部講演論文集
-
日本機械学会九州支部講演論文集 2019.72 (0), A43-, 2019
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390283659853940608
-
- NII論文ID
- 130007801888
-
- ISSN
- 24242780
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可