Nonlinear Multiple Regression Model and Optimization of Process Parameters for Weld Bonding of DP780 High Strength Steel

DOI Web Site Web Site 被引用文献1件 参考文献10件
  • Yi Jinquan
    Faculty of Mechanical and Electrical Engineering, Kunming University of Science and Technology
  • Zeng Kai
    Faculty of Mechanical and Electrical Engineering, Kunming University of Science and Technology
  • He Xiaocong
    Faculty of Mechanical and Electrical Engineering, Kunming University of Science and Technology
  • Xing Baoying
    Faculty of Mechanical and Electrical Engineering, Kunming University of Science and Technology
  • Feng Yuyang
    Faculty of Mechanical and Electrical Engineering, Kunming University of Science and Technology

この論文をさがす

抄録

<p>Based on the Box-Behnken Design (BBD) method, the experiment on weld bonding for DP780 high-strength steel was carried out. The failure load, nugget diameter and energy absorption value of the joints were viewed as the target quantities. The welding current, welding time, electrode pressure and interaction between the parameters were defined as the factors to influence the target quantities. The nonlinear multiple regression model of the weld-bonded joints for DP780 high strength steel was established. The experimental verification shows that the model has high saliency and high degree of fitting, which can effectively predict the failure load, nugget diameter and energy absorption value of the joints. With the increase of welding current and time, the failure load of the weld-bonded joints, the diameter of the nugget and energy absorption value increase, while they decrease with the increase of electrode pressure. The optimal process parameters are welding current 8 kA, welding time 150 ms, electrode pressure 0.3 MPa, which are obtained by the regression model, and the actual value of joint’s failure load under the shear test is 17669 N. The ultrasonic C-scan image is used to identify the gasification zone of the adhesive layer outside the weld nugget. When the welding time is small, the increase of the welding current will provide more heat input, which will lead to an increase in the burning area of the adhesive layer and reduce the static properties of the joints.</p>

収録刊行物

  • MATERIALS TRANSACTIONS

    MATERIALS TRANSACTIONS 61 (4), 700-707, 2020-04-01

    公益社団法人 日本金属学会

被引用文献 (1)*注記

もっと見る

参考文献 (10)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ