Time-Dependent Springback of Various Sheet Metals: An Experimental Study

DOI HANDLE Web Site Web Site 被引用文献1件 参考文献33件 オープンアクセス

この論文をさがす

抄録

<p>In the present study, draw-bending tests were conducted to investigate the effects of holding time at the bottom dead center (holding-time dependency) and elapsed time after releasing from dies (elapsed-time dependency) on springback in steel, Al alloy, Mg alloy, and CP-Ti sheets experimentally. The amount of springback decreased with increasing the holding time, irrespective of the material. The decreasing amounts from the holding time of 5 min to 600 min were 29%, 11%, 8.1%, and 5.7% respectively for the Mg alloy, CP-Ti, Al alloy, and steel sheets. On the contrary to previous studies, it was presumed from simple analyses that the holding-time dependency would presumably be explained in terms of not only stress relaxation but also unloading behavior following stress relaxation. The amount of springback gradually increased with the elapsed time regardless of the material. The amounts of increase from just after releasing from dies were approximately 5.9% for one month in the CP-Ti sheet, 4.1% for 1.5 months in the Al alloy sheet, 1.6% for 1.5 months in the Mg alloy sheet, and 1.1% for 1.5 months in the steel sheet. This magnitude relationship was different from that of creep strains, indicating that the mechanism of the elapsed-time dependency could not be explained only from the creep behavior and there would be other factors that affect the elapsed-time dependency.</p>

収録刊行物

  • MATERIALS TRANSACTIONS

    MATERIALS TRANSACTIONS 61 (5), 941-947, 2020-05-01

    公益社団法人 日本金属学会

被引用文献 (1)*注記

もっと見る

参考文献 (33)*注記

もっと見る

関連プロジェクト

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ