Rapid Fabrication of a Pumpless PDMS Microfluidic Device Using CO2 Laser Micromachining for Automated Formation of Monodisperse Water-in-Oil Droplets
-
- Shotaro Okayama
- Department of Chemical Engineering and Materials Science, Faculty of Science and Engineering, Doshisha University, Kyotanabe, Kyoto 610-0321 , Japan
-
- Masaya Nakatani
- Department of Chemical Engineering and Materials Science, Faculty of Science and Engineering, Doshisha University, Kyotanabe, Kyoto 610-0321 , Japan
-
- Masahiko Hashimoto
- Department of Chemical Engineering and Materials Science, Faculty of Science and Engineering, Doshisha University, Kyotanabe, Kyoto 610-0321 , Japan
抄録
<jats:title>Abstract</jats:title> <jats:p>To form monodisperse water-in-oil droplets in a fully automated fashion, we fabricated a pumpless microfluidic device consisting of top and bottom polydimethylsiloxane slabs. All microstructures required for droplet formation were directly patterned on the surfaces of two polydimethylsiloxane slabs using CO2 laser micromachining, facilitating rapid fabrication of the current device. This device formed uniformly sized droplets (a coefficient of variation for droplet diameters of <4%) at a rate of ∼220 droplets/s.</jats:p>
収録刊行物
-
- Chemistry Letters
-
Chemistry Letters 51 (2), 212-216, 2021-10-30
Oxford University Press (OUP)
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1360854108069663744
-
- NII論文ID
- 130008161589
-
- ISSN
- 13480715
- 03667022
-
- データソース種別
-
- Crossref
- CiNii Articles
- KAKEN