Pattern Shape Optimization of a Two Piece Brassiere Cup to Improve Its Design Efficiency
-
- Yoshida Kotaro
- Graduate School of Engineering, Osaka University
-
- Wakamatsu Hidefumi
- Graduate School of Engineering, Osaka University
-
- Morinaga Eiji
- Graduate School of Engineering, Osaka University
-
- Arai Eiji
- Graduate School of Engineering, Osaka University
-
- Tsutsumi Seiichiro
- Joining and Welding Research Institute, Osaka University
-
- Kubo Takahiro
- Wacoal Holdings Corporation
この論文をさがす
抄録
<p>A method to design the two-dimensional shapes of patterns of two piece brassiere cup is proposed. A brassiere cup consists of several patterns and their shapes are designed by repeatedly making a paper cup model and then checking its three-dimensional shape. This process requires much trial and error and would benefit from an improvement in design efficiency. The form of a brassiere is characterized by two curves: the ridge line and the lower edge of the cup. If their three-dimensional shapes are determined, the two-dimensional shape of a pattern must be designed so that its edges coincide with individual curves. When the two-dimensional shape of an edge of a paper pattern and the three-dimensional shape of a target curve are given, the surface of the pattern is uniquely determined. This means that the surface of the pattern is obtained from one edge and one target curve and another surface of the pattern is obtained from the other edge and the other target curve. Then, the pattern can be designed by optimizing both shapes of edges so that both surfaces completely overlap each other. It was experimentally verified that the edges of a designed pattern formed the target shapes.</p>
収録刊行物
-
- システム制御情報学会論文誌
-
システム制御情報学会論文誌 32 (5), 192-202, 2019-05-15
一般社団法人 システム制御情報学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282763133813760
-
- NII論文ID
- 130007690188
-
- NII書誌ID
- AN1013280X
-
- ISSN
- 2185811X
- 13425668
-
- NDL書誌ID
- 029672744
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可