Plasticity of metals and alloys : ISPMA 6 : proceedings of an International Symposium, held in Prague, Czech Republics, September 5-9, 1994

著者

• International Symposium on Plasticity of Metals and Alloys
• Lukáč, P. (Pavel)

書誌事項

Plasticity of metals and alloys : ISPMA 6 : proceedings of an International Symposium, held in Prague, Czech Republics, September 5-9, 1994

editor: Pavel Lukác

（Key engineering materials, 97-98）

Trans Tech Pub., c1994

注記

Includes bibliographical references and index

内容説明・目次

内容説明

Volume is indexed by Thomson Reuters CPCI-S (WoS). Confirming the fact that the various phenomena related to plasticity of metals and alloys continue to constitute a highly active field of research where many interesting developments are currently taking place, this volume presents 63 articles by well-known experts, on the topics of current interest.

目次

Enhancement of Properties and Performance of Materials by Rapid Solidification Processing Mechanical Properties and Thermal Stability of Rapidly Solidified Magnesium Alloys Annealing Effects in Melt Spun Microcrystalline Ribbons of Mg-Y and Mg-Nd Alloys Deformation of Short Fibre Reinforced Mg Alloys Caused by Thermally Induced Stresses Deformation Structure of Water Atomised and Extruded Cu-Cr-Zr Alloys Mechanical Properties of Fe-6.5%Si Ribbons Produced by Planar Flow Casting Structural Model of Ultrafine Grained Materials Produced by Severe Plastic Deformation High Temperature Stability of an Al-Zr-Ti Alloy Changes of Phase Composition in Nanocrystalline Fe-C and Fe-Ni-C Induced by Severe Deformation Structural Investigations of Ultrafine Grained Germanium Produced by Severe Plastic Deformation Plastic Deformation of Fine-Grained Structures Produced from Amorphous Alloys at Elevated Temperatures On a Physical Nature of the Yield Stress Anisotropy of Amorphous Alloys Ribbons Stress Induced Reordering in Amorphous Metals Analyzed by Relaxation Time and Activation Energy Spectrum Model On Causes of High Local Plasticity of a Bulk Cu50Zr35Ti8Hf5Ni2 Amorphous Alloy during Low Temperature Shear Failure under Compression Superplasticity in Ultrafine-Grained Materials Microstructure and Mechanical Properties of Ultrafine-Grained Materials Phenomenological and Mechanistic Approaches to Optimal Structural Superplasticity Superplasticity in a Powder Metallurgy Al-Zn-Mg-Cu-Zr Alloy Investigation of the High Temperature Plasticity of Materials by Indentation Measurements The Interpretation of Hardness Measurements Applied for the Determination of the Strain Rate Sensitivity Grain Boundary Character Distribution and Mechanical Properties of Austenitic Stainless Steels Plastic Deformation of Ordered Intermetallic Alloys: Fundamental Aspects The Stress Anomalies in TiAl: A Consequence of Mobile Dislocation Exhaustion Non-Equilibrium Dissociations of Dislocations Determination of the Dislocation Structure in Fe70Al30 Directional Coarsening in Single Crystal Nickel Based Superalloys: A Simulation Strain and Strain Rate Softening Instabilities: Length Scales and Spatial Couplings On the Relations between Portevin Le Chatelier Plastic Instabilities and Precipitation Onset of Discontinuous Flow in Cu-Be Alloys Jerky Flow in Al-Li-Mg-Cu Alloy The Portevin-Le Chatelier Effect in Cu-Al Single Crystals Investigated by Acoustic Emission and Slip Line Cinematography Structural Aspects of Portevin-Le Chatelier Phenomenon in Polycrystalline Alpha Titanium Dynamical Effects in Crystal Plasticity Effects of Non-Equilibrium Vacancies on Strengthening Kinetics of Plastic Deformation Introduction of 'Equivalent Deformation Mechanisms' for the Description of FCC Crystals Post-Stage-II Plasticity Kinematics Microstructure and Strain Hardening of Steels Evolution of Microstructural Parameters in Large Strain Deformation: Description by Zehetbauer's Model Large Strain Deformation of Al-Cu Solid Solutions Using Channel-Die Compression Microstructure and Mechanical Properties of A 6063 Aluminium Alloy at High Temperature Dynamic Recovery in Cu-9Ni Alloy at Low Temperatures Softening during Deformation of Zr Alloys Description of the Deformation Behaviour of Al-5Zn-1.2Mg Alloy The Relation between Forest Dislocations and Stress in BCC Metals Short Range Interaction between Dislocations Interpretation of Primary Creep Based on Constant Structure Experiments Analysis of Constant Structure Behaviour in Zinc The Effect of the Prestrain on Shearing Stress of Zinc Monocrystals in the (0001) <11-20> System Acoustic Emission from Deformed Zn Single Crystals Plastic Deformation of Polycrystalline Zn-0.25%Cd Alloy and Linear Location of Acoustic Emission Effect of Sense of Loading on Martensitic Transformations in Cu-Al-Ni Single Crystals Orientation Dependence of -T Phase Diagrams for Martensite Transformations in Cu-Al-Ni Single Crystals Effect of Deformation Mechanisms on Dynamic Recrystallization of Ferrite Stainless Steel Plasticity of Cubic Zirconia between 700 DegreesC and 1150 DegreesC Observed by Macroscopic Compression and by In Situ Tensile Straining Tests Internal Stresses and Microstructure in Plastically Deformed Metals and Alloys as Revealed by Asymmetric X-Ray Line Broadening Long-Range Internal Stresses in the Transition from Cell to Subgrain Structures Elastic-Plastic Response of Cracked Crystals Low-Temperature Dislocation Relaxation Processes in Niobium of Different Purity An Unified Model of Sweeping and Drift Mechanisms of the Formation of Dipolar Dislocation Structures Dipolar Dislocation Patterns in the Primary Slip Plane One Dimensional Model of Vein Structure Evolution A Model of Long-Range Internal Stresses and Glide Dislocation Shapes in Dislocation Wall Structures On the Localization of the Plastic Flow in Polycrystals of Austenitic Stainless Steel

「Nielsen BookData」 より

詳細情報

• NII書誌ID(NCID): BA25229989
• ISBN:
  • 0878496874
• 出版国コード: sz
• タイトル言語コード: eng
• 本文言語コード: eng
• 出版地: Aedermannsdorf
• ページ数/冊数: xvii, 514 p.
• 大きさ: 25 cm
• 親書誌ID:
  • BA1292205X