Digital signal transmission : line circuit technology
著者
書誌事項
Digital signal transmission : line circuit technology
Chapman and Hall, 1988
1st ed
大学図書館所蔵 全2件
  青森
  岩手
  宮城
  秋田
  山形
  福島
  茨城
  栃木
  群馬
  埼玉
  千葉
  東京
  神奈川
  新潟
  富山
  石川
  福井
  山梨
  長野
  岐阜
  静岡
  愛知
  三重
  滋賀
  京都
  大阪
  兵庫
  奈良
  和歌山
  鳥取
  島根
  岡山
  広島
  山口
  徳島
  香川
  愛媛
  高知
  福岡
  佐賀
  長崎
  熊本
  大分
  宮崎
  鹿児島
  沖縄
  韓国
  中国
  タイ
  イギリス
  ドイツ
  スイス
  フランス
  ベルギー
  オランダ
  スウェーデン
  ノルウェー
  アメリカ
注記
Includes bibliographical references (p. 139-141) and index
内容説明・目次
内容説明
The coming of digital electronics has given rise to many textbook- outstanding among which are the authoritative works of Douglas Lewin- dealing, in the main, with the combinational and sequential logic aspects of system design. By comparison, the coverage of digital hardware has been meagre: in particular, books on logic circuit interconnections have been scarce in number. When circuits operated at relatively low speeds this did not cause major problems to engineers and students, but the increasing use of fast, and very fast, logic circuits employed extensively in modern digital systems has brought the requirement for properly-designed transmission paths between printed circuit boards, on the boards, and even in the integrated circuit packages themselves. turn, has necessitated a physical understanding of line pulse This, in behaviour, and an ability to design practically appropriate interconnection systems, by a far wider audience of engineers, scientists and students than has been the case hitherto. For many years the study of transmission lines was, primarily, the province of the telecommunications engineer sending high-frequency radio signals to antennas for radiation into space, and the power engineer working at low frequencies (50/60 Hz) but with corresponding wavelengths comparable with the relatively large distances involved in the supply of power from generating stations to remote users. The textbook treatment of lines was well established, but based mainly on the assumption of sinusoidal signals. This 'frequency-domain' approach is not best suited to the understanding of the transmission of digital signals.
目次
1 Lumped and distributed circuits.- 2 Characteristics of ideal transmission lines/cables.- 2.1 Equations for an ideal line.- 2.2 Possibility of line pulse reflections.- 2.3 Matching and mismatching.- 2.4 'Phantom generator' interpretation of reflections.- 3 The reflection chart.- 3.1 The Reflection Chart: step-input voltage.- 3.2 Rectangular pulse drive.- 3.3 Input waveforms with finite rise- and fall-times.- 4' sliding-Load-Line' analysis of pulses on lines.- 4.1 Resistive terminations.- 4.2 Nonlinear load: a diode termination.- 4.3 Reflections with logic circuit interconnections.- 5 Time domain reflectometry.- 5.1 Application examples: step and truncated-ramp drive.- 6 Crosstalk.- 6.1 Crosstalk with strip lines.- 6.1.1 Forward crosstalk waveform: derivation.- 6.1.2 Reverse crosstalk waveform: derivation.- 6.1.3 Crosstalk: calculation examples.- 6.1.4 Reduction of crosstalk with microstrip lines.- 6.2 Crosstalk with cable bundles: general comments.- 7 Logic signal transmission: an introduction.- 7.1 Transmission characteristics.- 7.1.1 Parallel and serial data transfer.- 7.1.2 Unbalanced and balanced operation.- 7.1.3 Tri-state operation.- 7.2 Noise rejection in unbalanced and balanced systems.- 7.3 Single-ended, point-to-point transmission: RS232C.- 7.4 Multi-point bidirectional data transmission: RS485.- Appendix A: Resume of practical line characteristics.- Appendix B: Laboratory demonstration work.- General considerations.- Circuit descriptions and observed waveforms.- Appendix C: General notes on waveform observation.- Lumped systems.- Distributed systems.- Answers (including worked solutions to problems).- References.
「Nielsen BookData」 より