Atlas of limit loads of metal plates, shells, and disks
著者
書誌事項
Atlas of limit loads of metal plates, shells, and disks
Elsevier, 1995
- acid-free paper
大学図書館所蔵 全2件
  青森
  岩手
  宮城
  秋田
  山形
  福島
  茨城
  栃木
  群馬
  埼玉
  千葉
  東京
  神奈川
  新潟
  富山
  石川
  福井
  山梨
  長野
  岐阜
  静岡
  愛知
  三重
  滋賀
  京都
  大阪
  兵庫
  奈良
  和歌山
  鳥取
  島根
  岡山
  広島
  山口
  徳島
  香川
  愛媛
  高知
  福岡
  佐賀
  長崎
  熊本
  大分
  宮崎
  鹿児島
  沖縄
  韓国
  中国
  タイ
  イギリス
  ドイツ
  スイス
  フランス
  ベルギー
  オランダ
  スウェーデン
  ノルウェー
  アメリカ
注記
Includes bibliographical references
内容説明・目次
内容説明
This Atlas collects the results disseminated in the vast scientific literature on the evaluation of limit loads for metal plates, shells and disks. After a first, introductory chapter, summarizing briefly the theory of limit loads, the following four chapters deal successively with circular and noncircular plates, cylindrical shells, general shells and disks. Each chapter is self-contained, beginning with its own theoretical introduction and its literature references. The limit loads are given either by formulas (when possible) or by graphs or tables. When they are obtained by computer programmes, as much information as possible is given on the availability of these programmes. Each chapter contains a list of patterns (types of structures and support conditions) and loadings treated in the chapter. For each limit load, the following features are indicated: the yield condition used (Von Mises, Tresca, isotropic or orthotropic, including shear or not, exact or approximate), the fact that it is either a complete solution or a lower (upper) bound, and the possible existence of experimental verification.
In a large majority of cases, fields of generalized stresses and strain rates at collapse are given in appendices. The Atlas is intended to be updated every few years. For easy use, printing is one-sided (except introductions and lists of references), so that pages for a given case can be extracted from the book without overlapping two different cases on the same page.
目次
- Introduction - general features of limit load evaluations
- plates in bending, J. Sokol-Supel - circular plates, non-axisymmetric plates
- cylindrical shells, G. Guerlement and D. Lambin
- shells, F. Badin
- disks, E. Rogalska.
「Nielsen BookData」 より