Microsystem design
著者
書誌事項
Microsystem design
Kluwer Academic Publishers, c2001
大学図書館所蔵 全23件
  青森
  岩手
  宮城
  秋田
  山形
  福島
  茨城
  栃木
  群馬
  埼玉
  千葉
  東京
  神奈川
  新潟
  富山
  石川
  福井
  山梨
  長野
  岐阜
  静岡
  愛知
  三重
  滋賀
  京都
  大阪
  兵庫
  奈良
  和歌山
  鳥取
  島根
  岡山
  広島
  山口
  徳島
  香川
  愛媛
  高知
  福岡
  佐賀
  長崎
  熊本
  大分
  宮崎
  鹿児島
  沖縄
  韓国
  中国
  タイ
  イギリス
  ドイツ
  スイス
  フランス
  ベルギー
  オランダ
  スウェーデン
  ノルウェー
  アメリカ
注記
Includes index
Bibliography: p.[665]-676
内容説明・目次
内容説明
It is a real pleasure to write the Foreword for this book, both because I have known and respected its author for many years and because I expect this book's publication will mark an important milestone in the continuing worldwide development of microsystems. By bringing together all aspects of microsystem design, it can be expected to facilitate the training of not only a new generation of engineers, but perhaps a whole new type of engineer - one capable of addressing the complex range of problems involved in reducing entire systems to the micro- and nano-domains. This book breaks down disciplinary barriers to set the stage for systems we do not even dream of today. Microsystems have a long history, dating back to the earliest days of mic- electronics. While integrated circuits developed in the early 1960s, a number of laboratories worked to use the same technology base to form integrated sensors. The idea was to reduce cost and perhaps put the sensors and circuits together on the same chip. By the late-60s, integrated MOS-photodiode arrays had been developed for visible imaging, and silicon etching was being used to create thin diaphragms that could convert pressure into an electrical signal. By 1970, selective anisotropic etching was being used for diaphragm formation, retaining a thick silicon rim to absorb package-induced stresses. Impurity- and electrochemically-based etch-stops soon emerged, and "bulk micromachining" came into its own.
目次
Foreword. Preface. Acknowledgments. Part I: Getting Started. 1. Introduction. 2. An Approach to MEMS Design. 3. Microfabrication. 4. Process Integration. Part II: Modeling Strategies. 5. Lumped Modeling. 6. Energy-Conserving Transducers. 7. Dynamics. Part III: Domain-Specific Details. 8. Elasticity. 9. Structures. 10. Energy Methods. 11. Dissipation and the Thermal Energy Domain. 12. Lumped Modeling of Dissipative Processes. 13. Fluids. Part IV: Circuit and System Issues. 14. Electronics. 15. Feedback Systems. 16. Noise. Part V: Case Studies. 17. Packaging. 18. A Piezoresistive Pressure Sensor. 19. A Capacitive Accelerometer. 20. Electrostatic Projection Displays. 21. A Piezoelectric Rate Gyroscope. 22. DNA Amplification. 23. A Microbridge Gas Sensor. Appendices: A. Glossary of Notation. B. Electromagnetic Fields. C. Elastic Constants in Cubic Material. References. Index.
「Nielsen BookData」 より