CiNii 図書 - Earthquake resistant engineering structures III

Based on the proceedings of the Third International Conference on Earthquake Resistant Structures (ERES), this book presents basic and applied research in the main fields of engineering relevant to earthquake resistant analysis and design of structural systems. The challenge of protecting the built environment in the earthquake-prone regions of the world can be divided into two: the optimal design and construction of new facilities and the upgrading and rehabilitation of existing structures. While the former is within the realm of modern technology, the latter remains a daunting and expensive task that can be accomplished only gradually. The inestimable loss of life and the colossal costs incurred following a major earthquake, however, provide sufficient incentive for the scientific and technical communities to expend considerable time and effort on this challenge. The papers presented in this volume provide a comprehensive review of state-of-the-art developments in these important topics and will be of interest to all specialists working in these areas.Over 70 contributions are included and these cover: Earthquake Resistant Analysis and Design; Seismic Risk Reduction; Building Structures; Reinforced Concrete Structures; Retrofitting and Repairs; Soil Dynamics; Underground and Lifeline Structures; Bridges; and Special Structures.

Section 1: Earthquake resistant analysis and design On the evaluation of probabilistic displacement spectra
Random vibration of structures with strong non-linearities subjected to seismic excitation
Evaluation of proper supplemental damping for a multi-story steel frame using capacity spectrum method
Seismic design - classic and new approaches
Estimation method of requisite strength to control deformation of RC structure under earthquake motion and investigation of the accuracy
Plastic energy as a design parameter
Strength reduction factors for structures that simultaneously dissipate plastic and viscous energy
Seismic response of buildings with setback
Effect of structural irregularities and short columns on the seismic response of buildings during last Turkey earthquakes
Stochastic seismic induced effects in dam-reservoir systems
Equivalent SDOF systems for the estimation of seismic response of multistory frame structures
Re-evaluation of seismic capacity of interior beam-column joints. Section 2: Seismic risk reduction Optimal strategies for seismic risk reduction
Performance of distributed base isolation system for masonry buildings
Importance of eccentricities in the superstructure on the torsional response of base-isolated structures
Design and characteristics of high damping natural rubber bearings for base isolation
Seismic isolation and site effects, an inter-disciplinary investigation at the seismic test site INCERC, Bucharest, Romania
A new elastic-plastic dissipation device for seismic protection of the bridge pier structures: design and numerical investigation
Ground motion and structural vibration reduction using periodic wave barrier as a passive isolation
Self variable stiffness system for optimal seismic response of RC frame with concrete braces
Effects of damping matrix in the response of structures with added linear viscous dampers
A building with TLD to earthquake
Employing glass panels with rounded corners to mitigate seismic damage in architectural glass wall systems
Reducing hazards due to architectural elements in buildings subject to earthquakes
Time-domain analysis of structures with dampers modelled by fractional derivatives
Numerical simulation of structures equipped with friction energy dissipation devices subjected to seismic load
Using genetic algorithm for optimal control force in active vibration control. Section 3: Building structures The performance of reinforced masonry piers subjected to horizontal cyclic loading
Requirements for performance based design of buildings
Pseudodynamic tests on full scale masonry walls
Seismic-damage quantification for brick infills of RC frames. Section 4: Reinforced concrete structures A comparison of nonlinear models for reinforced concrete frames
Model simulation of damage pattern and response of multi-storeyed RCC framed structure subjected to ground shock
The influence of P-? effects on seismic response of RC framed structures
The review of strut and tie models suggested for exterior beam column connections
Seismic design of R/C frames: An assessment of the behaviour factor
Failure mechanism of RC beam under reversed cyclic loading after flexural yielding caused by lateral strain accumulation in plastic-hinging region
Stress-strain behavior in compression of lightweight fiber reinforced concrete under monotonic and cyclic loads
Comprehensive behaviour of R.C. members strengthened with carbon fiber reinforced plastic layers
Reliability of pushover analysis - based methods for seismic assessment of R/C buildings
Two parameters analysis of post-peak dynamic behaviour of high performance concrete
Performance based modeling and evaluation of joint mechanics. Section 5: Retrofitting and repairs Assessment of the seismic resistant capacities of traditional masonry buildings and retrofitting interventions to reduce their vulnerability
Three-dimensional IT investigation of seismic distress in a large existing structure and development of remedial measures
Seismic upgrade of a reinforced concrete building
Retrofitting of large water retaining structures to withstand earthquakes
Some experiences about the retrofitting of tower masonry structures
Retrofitting of reinforced concrete beams using externally bonded FRP plates
Repair of slab-column connections using CFRP
Calculation of costs for seismic rehabilitation of historical buildings. Section 6: Soil dynamics Harmonic response of a rigid wall retaining poroelastic soil by direct approach
Numerical analysis of non-linear soil-structure interaction
Identification of dynamic soil resistance to piles with consideration of system uncertainties
Development of an in situ method to measure nonlinear soil behavior
Spatial distribution of the ground motion during the 1999 Chi-Chi earthquake based on the wavelet transform
Comparison between numerical and experimental behaviour of granular soil. Section 7: Underground and lifeline structures Seismic design of tunnels
Inelastic response of 3-D underground structures in rock under seismic loading
Dynamic response of underground structures in soils with variable mechanical properties
Seismic design of buried pipelines for liquefaction-induced large ground displacement
Pre-stressed concrete large-diameter pipes: joint behaviour during earthquakes. Section 8: Bridges Study on the seismic retrofit of a steel cable-stayed bridge
Investigation of earthquake resistance and cost effect on hybrid cable-stayed bridge with two girders
Masonry bridge with five long span arches: computer modelling analysis of failures and repairs
Vulnerability of Pony Truss bridges
Study of the nonlinear behavior of the prestressed concrete girders by a neural network
Seismic analysis and design of R/C bridge including SSI effects
Static and dynamic behaviour of an historical stone bridge investigated by means of a 3D numerical model. Section 9: Special Structures A 3-D boundary element model for the dynamic analysis of arch dams with porous sediments
Seismic response of Mullardoch Dam: a case study
Seismic response of thin shell storage tanks
Seismic response of a historical Mamluk style minaret
Low cost earthquake resistant reinforcement for adobe houses.

「Nielsen BookData」より

Earthquake resistant engineering structures III

著者

書誌事項

大学図書館所蔵全2件

この図書・雑誌をさがす

注記

内容説明・目次

関連文献： 1件中 1-1を表示

詳細情報

書き出し