Energy and environment engineering and management : selected, peer reviewed papers from the 3rd International Congress of Energy and Environment Engineering and Management, Portalegre, Portugal, 25th to 27th November 2009
著者
書誌事項
Energy and environment engineering and management : selected, peer reviewed papers from the 3rd International Congress of Energy and Environment Engineering and Management, Portalegre, Portugal, 25th to 27th November 2009
（Advanced materials research, v. 107）
Trans Tech Publications, c2010
- : pbk.
大学図書館所蔵 全1件
注記
Includes bibliographical references and index
内容説明・目次
内容説明
This collection comprises selected papers from the 3 rd International Congress on Energy and Environment Engineering and Management. Each Congress provides an opportunity for academics, scientific consultants and companies to share days of interaction that permit the free interchange of experience and, at the same time, create and renew links between different work-groups. This Congress included a total of six thematic areas, covering a broad spectrum within the applications associated with environmental engineering, energy installations, renewable energy, electromechanics, materials and project engineering. The contents therefore provide a handy introduction to the subject.
目次
Committees
Sponsors
Preface
Activated Carbons Prepared from Natural and Synthetic Raw Materials with Potential Applications in Gas Separations
Sustainable Manufacturing in Aerospace Industry - Analysis of the Viability of Intermediate Stages Elimination in Sheet Processing
Low Environmental Impact Machining Processes of Composite Materials Applied to the Aerospace Sector
Sand Mining Pool Eutrophication (Vale do Paraiba, Sao Paulo, Brazil): Preliminary Assessment
Recovery of Degraded Areas in Vale do Paraiba, Sao Paulo, Brazil: Performance Indicators
Surface Wave Energy Capture System (A New Proposition)
Environmental Education and Energetic Efficiency: Reports on Brazilian Projects in the Sake of Socio-Environmental Sustainability
Free Cooling with Phase Change Materials (PCM)
Interface Potential Modeling in a Finite Crystal
Hydrothermal Stability of Ordered Mesoporous Titanosilicate Materials Prepared at Room Temperature
Composites in the Design Optimization of Biconvex Refractive Solar Concentrators. Study and Calculation of Prototypes
SOM-SEM-EDS Identification of Tool Wear Mechanisms in the Dry-Machining of Aerospace Titanium Alloys
Ecological Design, an Objective in the Projects Engineering Area
Use of Centrifugal Pumps Operating as Turbines for Energy Recovery in Water Distribution Networks. Two Case Study
Leds, toward the Best Energy Efficiency in Lighting
Comparison of Simple Illuminance Model Performances under Clear-Sky Conditions for Athens (Greece)
Study of Thermal Conductivity of Materials Made of Sludges Water Depuration of the Brewing Industry
Treatment of Urban Waste Water Sludges by Means of his Appraisement for Incorporation in Ceramic Matrix
Preliminary Study of the Influence of Machining Conditions in the Response to Corrosion of UNS-A92024 Alloy
Computer Simulation and Depth Profiling of Light Nuclei by Nuclear Techniques
Environmental, Energetic and Economic Analysis about the Energy Source for a Vehicle with Typical Portuguese Urban Use
Identification, Analysis and Evolution of the Mechanisms of Wear for Secondary Adhesion for Dry Turning Processes of Al-Cu Alloys
Radiation Safety of Old Uranium Mining Waste Dumps in Portugal
Environmental Remediation and the Legacy of Uranium Mining Waste in Portugal and Europe. Lessons to Retain
「Nielsen BookData」 より