Advanced development of engineering science IV : selected, peer reviewed papers from the 2014 4th International Conference on Automation, Communication, Architectonics and Materials (ACAM 2014), September 27-28, 2014, Wuhan, China
Author(s)
Bibliographic Information
Advanced development of engineering science IV : selected, peer reviewed papers from the 2014 4th International Conference on Automation, Communication, Architectonics and Materials (ACAM 2014), September 27-28, 2014, Wuhan, China
（Advanced materials research, v. 1046）
Trans Tech Publications, c2014
- : pbk
Available at / 1 libraries
-
No Libraries matched.
- Remove all filters.
Note
Includes bibliographical references and indexes
Description and Table of Contents
Description
Volume is indexed by Thomson Reuters CPCI-S (WoS).
Collection of selected, peer reviewed papers from the 2014 4th International Conference on Automation, Communication, Architectonics and Materials (ACAM 2014) September 27-28, 2014, Wuhan, China.
The 122 papers are grouped as follows:
Chapter 1: Materials Science, Chemical Materials and Chemical Technologies;
Chapter 2: Biomedical Engineering;
Chapter 3: Architectonics and Construction;
Chapter 4: Designing and Researches in Machinery;
Chapter 5: Advanced Technologies in Mechatronics, Automation and Control;
Chapter 6: Communication and Networks;
Chapter 7: Computation Methods and Algorithms, Data Processing;
Chapter 8: Applied Information Technologies;
Chapter 9: Engineering Management and Production Management
Table of Contents
Preface, Committees and Sponsors
Chapter 1: Materials Science, Chemical Materials and Chemical Technologies
Study on Damping Properties of Fe12O19Sr/NBR Composite
Material Properties and Optimization Design of Tennis Adhesive Formations
Preparation of Pineapple Leaf Cellulose Membrane
Progress in the Studies of Multifunctional Triphenylamine Materials
Synthesis and Property Analysis of Hydrophobic Modification Guar Gum
Preparation and Characterization of Boron Carbon Nitride Films on High Speed Steel Surface
Experimental Study on Combustion and Explosion Characteristics of Diesel
2-Naphthalenesulfonic Acid Adsorption on Composite Weakly Basic Resin
Synthesized and Preparation of Side Chains Containing Nitrogen Atoms Sulfonated Polyimide Membranes
Optimization of Operating Mode in Copper Flash Smelting Process
Effect of Artificial Aging on Salt Spray Corrosion Resistance of 2024 Al Alloy
Hardness and Corrosion Behavior of Aged 6063 Al Alloy
Microstructure and Property Study on Wear Resistant Composite Coating Produced by Ultrasonic-Assisted Argon-Arc Clad Injection
Friction and Wear Performances of n-Na2B4O7/Ion Nitrocarburized Duplex Layer at Different Frequences
Separation Status of Discarded or Obsolete TNT/RDX/Al Explosive Based on Material Properties
Biodegradation of Aniline by Alkaliphilic Strain Bacillus sp. Strain AN2 under High Salinity Condition
Computation for Equation of States of (Mg0.92, Fe0.08)SiO3 Perovskite Based on Mie-Gruneisen-Debye Model
Chapter 2: Biomedical Engineering
Applied Technology in Feasibility Assessment of Photoplethysmograph Computing for Heart Rate Variability Application
Research on Image Segmentation Technology with Tissue Section Cell Segmentation Algorithm
Applied Technology with an Improved ICA Algortihm and its Application in Heart Rate Measurement
Facile Synthesis of Symmetrical Homonucleotides of Antiviral Nucleosides
A Synthetic Approach for the Preparation of P1-AZT-5'-P3-d4T-5'-Triphosphate
Synthesis of Phosphonate-Containing 2-Methyl-1,5-Diaminopentane Derivatives
Synthesis of Two Analogs of AKT Inhibitor-IV via Amine-Exchange Reactions
Synthesis of 5-Formyl-2'-Deoxycytidine and its Monophosphate
Laser Stimulation Control System Design of the Auditory Nerve
Chapter 3: Architectonics and Construction
Coordination of Road Construction Materials and the Environment
Quality Detection Techniques and Assessment Method of Highway Projects
Research on Risk Evaluation of Investment Decision Stage Base on Sensitivity Analysis for Building Engineering Projects
Research on the Risk Evaluation of Construction Stage Base on Analytical Hierarchy Process for Building Engineering Projects
Construction Research by Introducing Sense of Place into Cultural Landscape Design in Ethnic Areas: A Tentative Approach to Intensify Place Identity
Architectural Research with Initial Exploration on New Chinese-Style Landscape Design Method
Construction Study on the Public Elderly-Care Facility in Xi'an
Construction Research with a New Research Method for Determining the Traffic Impact Scope
Chapter 4: Designing and Researches in Machinery
Stress and Fatigue Analysis of Elliptical Head with Multi-Opening in Thermal Environment
Calculation of Interaction Force between Pipe and Water of HVAC
Simulation of Constant Pressure in Water Supply System with Frequency Converter Based on Matlab
Design and Kinematic Analysis of Planar Four-Bar Linkages with an Object Oriented Python Program
Aerodynamic and Numerical Study on the Influence of Spike Shapes at Mach 1.5
Simulation Analysis of Coupled Automobile Chassis Suspension and Steering System
Research on Mechanical Conditions of Vehicle Rollover at Corners
Analysis on Thermal and Flow Field of Four-Wheel Drive EV Controller
The Analysis of Direct Numerical Simulation and Experiment in Critical Point of Transitional Flow
Research on Detection of Transmission Line Porcelain Insulator Based on Infrared Technology
Research and Experiment on Energy Supplement Technology for Underwater Marine Instruments Based on Tidal Current Energy
The Structure Design and Numerical Simulation of Internal Flow Field with High Efficiency Low Resistance Cyclone
Chapter 5: Advanced Technologies in Mechatronics, Automation and Control
Energy Optimal Control of Induction Motor for Electric Vehicle Drive System Base DTC
Design of Automotive Intelligent Preloaded Safety Belt
The Design of Isolated RS485 Bus System Based on ATmega162
Research on Method of Process System with Error Tracing Based on PSO
Research on the KingSCADA Crude Oil Transmission Separator in Oil Level Automatic Control System
Research on Information Fusion Method to Improve the Measurement Precision of High Speed Vehicles Anti-Collision Distance
Research for Uniformity of Insulation Layer on Communication Cable Online Testing Control System
The Design of Automatic Control System for Industrialized Recirculating Aquaculture
A Fuzzy Logic Scheme for Lateral Control of an Unmanned Vehicle
Low-Power Design and Analysis of Heat Flux and Temperature Acquisition System
Applied-Information Technology in a Kind of SF6 Gas Density On-Line Monitoring System
Applied-Information Technology in Abnormal Detection for Surveillance Systems
Fault Diagnosis Based on Multi-Layer Structure Wavelet Neural Networks in Attitude Heading Reference System
Chapter 6: Communication and Networks
Multi-Thread Chain DMA Data Transfer Method for SuperSpeed Bus Video Transmissions
Compressed Sensing Aided Channel Estimation for Power Line Communications
Design of X-Band Frequency Source Based on PLL Technology
Design of Ka-Band Conformal Microstrip Patch Antenna
Research on the Single Target Recognition of Car Collision Avoidance Radar Based on the FMCW Technology
Design of the Parallel Coupled Microstrip Bandpass Filter
Design of Millimeter-Wave Emission Component
The Application of Broadband Power Line Carrier Communication in Electric Energy Data Acquisition Remote Communication
Generic and Automatic Multi-Channel Control System
Study on Dynamic Marshalling and Coupled Control of China's High-Speed Electric Multiple Unit
Research of Communication of Low Voltage Feed Switch Based on Power Line Carry
Applied Technology in Effectiveness Assessment of Communication Equipment Based on ADC
Research on Remote Fault Diagnosis System with Design of the Mine Enterprise Equipment Based on VPN
Novel Model of Wireless Sensor with Indoor Positioning Algorithm and Time Synchronization Protocol
Reliable Data Transmission Scheme Based on Network Coding in Wireless Sensor Network
A Semi-Persistent Scheduling Algorithm for VoIP in LTE-Advanced System
A Time Synchronization Algorithm Based on Cluster-Tree
The Design of Embedded Ethernet System Based Microcontroller
Chapter 7: Computation Methods and Algorithms, Data Processing
Research on Information Processing with Dynamic Adaptive Job Scheduling Algorithm Based on Hadoop Platform
Research on Information Processing with Delay Fair Scheduling Algorithm Based on Resource Situation
A Variables Clustering Based Differential Evolution Algorithm to Solve Multistage Goal Programming Model in Defense Projects Portfolio
Chaotic Clonal Genetic Algorithm for Routing Optimization
Projection Method for Material Selection Problem with Triangular Fuzzy Numbers
Applied-Information Technology in Adaptive Kalman Filter with Model Error and Noise Error
Applied-Information Technology with Speech Enhancement Based on EMD and MF
Information Processing with Fuzzy S-P Evaluation Method and Application in Evaluating Teaching Quality
Research on Applied-Information Technology Based on the Improved NCC Identification of Fruit and Vegetables
Data Processing in Biological Behavior Analysis of a Delayed Impulsive Lotka-Volterra Model with Mutual Interference
Data Processing with Combined Homotopy Methods for a Class of Nonconvex Optimization Problems
A General Model for Low-Illumination Video Enhancement
Applied Technology in Multidimensional Color Image Scaling Based on NASS in a Quantum System
Available Lane Detection Based on Radon Transform
Construction Research on Multi-Threshold Segmentation Based on Improved Otsu Threshold Method
Chapter 8: Applied Information Technologies
Research on Applied-Information Technology in Online Compact System Based on Serial Communication
Research on Applied-Information Technology with Data Distribution for Light Field Camera Array
Applied-Information Technology in Random Naming System Based on Image Processing and Application
Applied-Information Technology with Distributed Text Feature Extraction Method Based on MapReduce
The Application Research of the University Human Resource Systems Based on Virtualization Technology
Construction on the Automation and Digitization of Network for University Library
Applied-Information Technology in Improving Bloom Filter-Based Discovery Protocol for DDS Middlewarein Consideration of QoS
Research on Database and Information Technology in the Decision Tree of Communication Construction Scheme
Applied-Information Technology in Reconstruction of Crime Scene Based on Virtual Reality
Research on Data Processing in PLM Product Based on Cloud Platform
Applied Information Technology in KBE Based Intelligent Design System for Tricone Bits
Research on Applied Information Technology with Web Application in Online Cooperative Learning under Cognitive Styles
Applied-Information Technology with a Method of PLM Software in Component Library Development and Management Based on the Cloud Platform
A "Visible-and-Controllable" Smart Home System
Automation of Communication for Improving Autonomous Interpretation Abilities
An Improved Dynamic Trust Model for Distributed System
PBHT Scheduling Algorithm for Embedded Real-Time Systems
Virtual Machines Scheduling Algorithm Based on Multi-Objective Optimization in Cloud Computing
An Adaptive Decision Concurrency Control Algorithm
GIS Based Coal Seam Floor DEM Construction According to Floor Contours and Considering Faults Distribution
Information Processing and Applied Technology in Hunan's Forest Fire Risk Regionalization Based on GIS
Research on Application of Information Technology in Promoting Learners' Translation Competence and Self-Directed Learning
Chapter 9: Engineering Management and Production Management
Applied-Information Technology with Trust Risk Evaluation Method of Supply Chain Based on Theory of Rough Set and Uncertain Multiple Attribute Decision
Applied-Information Technology in Project Portfolio Risk Management System Based on Hall's Three-Dimensional Structure
Data Processing in Project Supply Chain Vendor Selection Based on Improved Entropy Weight - Grey Correlation - TOPSIS
Data Processing in Regional Energy, Economy and Environment System Development Theories Research
Data Processing in Scientific Research Performance Evaluation of University Based on DEA and Supervision Measures
Application of Forecasting Power Based on Neural Network and Wilcoxon Rank Sum Test
Study and Application of the Life-Cycle Cost Control Model of Water Conservancy and Hydropower Project Based on Entropy and FAHP
Data Processing in Spatial-Temporal Analysis of Long-Term Precipitation in Taihu Basin during 1951-2006
by "Nielsen BookData"
