Ultrasonic transducer materials
著者
書誌事項
Ultrasonic transducer materials
(Ultrasonic technology)
Plenum Press, 1971
大学図書館所蔵 全24件
  青森
  岩手
  宮城
  秋田
  山形
  福島
  茨城
  栃木
  群馬
  埼玉
  千葉
  東京
  神奈川
  新潟
  富山
  石川
  福井
  山梨
  長野
  岐阜
  静岡
  愛知
  三重
  滋賀
  京都
  大阪
  兵庫
  奈良
  和歌山
  鳥取
  島根
  岡山
  広島
  山口
  徳島
  香川
  愛媛
  高知
  福岡
  佐賀
  長崎
  熊本
  大分
  宮崎
  鹿児島
  沖縄
  韓国
  中国
  タイ
  イギリス
  ドイツ
  スイス
  フランス
  ベルギー
  オランダ
  スウェーデン
  ノルウェー
  アメリカ
注記
Includes bibliographical references
内容説明・目次
内容説明
In recent years remarkable progress has been made in the development of materials for ultrasonic transducers. There is a continuing trend towards increasingly higher frequency ranges for the application of ultrasonic trans- ducers in modern technology. The progress in this area has been especially rapid and articles and papers on the subject are scattered over numerous technical and scientific journals in this country and abroad. Although good books have appeared on ultrasonics in general and ultrasonic transducers in particular in which, for obvious reasons, materials play an important part, no comprehensive treatise is available that represents the state-of-the-art on modern ultrasonic transducer materials. This book intends to fill a need for a thorough review of the subject. Not all materials are covered of which, theoretically, ultrasonic trans- ducers could be made but those that are or may be of technical impor- tance and which have inherent electro acoustic transducer properties, i.e., materials that are either magnetostrictive, electrostrictive, or piezoelectric.
The book has been devided into three parts which somewhat reflect the historic development of ultrasonic transducer materials for important tech- nical application. Chapter 1 deals with magnetostrictive materials, magnetostrictive met- als and their alloys, and magnetostrictive ferrites (polycrystalline ceramics). The metals are useful especially in cases where ruggednes of the transducers are of overriding importance and in the lower ultrasonic frequency range.
目次
1 Magnetostrictive Metals and Piezomagnetic Ceramics as Transducer Materials.- 1 Introduction.- 1.1. Ultrasonic Generators and Detectors.- 1.2. Magnetostriction Filters.- 2. Fundamentals of Magnetostriction.- 2.1. Static Magnetostriction Phenomena.- 2.2. Magnetostrictive Forces.- 2.3. Magnetrostriction Constants.- 2.4. Material Criteria.- 2.5. Effect of Hydrostatic Pressure on Magnetostriction.- 2.6. Effect of Mechanical Stress on Magnetostriction.- 3. Eddy Current Effects on Material Constants.- 4. Relation between Static and Dynamic Magnetostriction Phenomena.- 5. Methods of Material Measurement.- 5.1. Motional Impedance Methods.- 5.2. Measurement under Hydrostatic Pressure.- 5.3. Measurement under Static Compressive Stress.- 6. Magnetostrictive Properties of Materials.- 6.1. Nickel.- 6.2. Ni-Fe Alloy.- 6.3. Al-Fe Alloy.- 6.4. Other metals.- 6.5. Cobalt Rondel.- 6.6. Ferrites.- 6.7. Theoretical Models for the Characteristics of Magnetostriction in Polycrystalline Metals.- 7. Consideration of Large Signal Operation.- 7.1. Theoretical Approach.- 7.2. Experimental Approach.- References.- 2 Piezoelectric Crystals and Ceramics.- 1. Introduction.- 2. Fundamentals of Piezoelectricity.- 2.1. Basic Action and Linear Static Equations.- 2.2. Effect of Crystal Symmetry.- 2.3. The Piezoelectric Coupling Factor.- 3. Modes of Vibration of Piezoelectric Elements.- 3.1. Low-Frequency Modes.- 3.2. High-Frequency or Thickness Modes.- 3.3. The Effective Coupling Factor-The Piezoelectric Resonator.- 4. Ferroelectricity.- 4.1. General Description.- 4.2. Piezoelectricity in Ferroelectrics-The Piezoelectric Ceramics.- 4.3. Nonlinearities-Domain Effects.- 4.4. Phase Transitions.- 5. Dissipation in Piezoelectric Materials.- 5.1. General.- 5.2. Effects on Transducer Efficiency and Power Capacity.- 6. Parameters of Important Piezoelectric Crystals.- 6.1. Older Piezoelectric Crystals.- 6.2. Newer Piezoelectric Crystals.- 7. Parameters of Piezoelectric Ceramics.- 7.1. General.- 7.2. Aging in Piezoelectric Ceramics and Effects of High Static Stress.- Notation.- References.- 3 Piezoelectric Transducer Materials and Techniques for Ultrasonic Devices Operating Above 100 MHz.- 1. Introduction.- 1.1. Scope of Chapter.- 1.2. Results from the Equivalent Circuit Analysis of High-Frequency Ultrasonic Devices Using Piezoelectric Transducers.- 1.3. Properties of Transducer Materials and Acoustic Materials of Interest for High-Frequency Applications.- 2. Materials and Techniques for Bonded Plate Transducers.- 2.1. Single-Crystal Materials.- 2.2. Ceramic Transducer Materials.- 2.3. Bonding and Lapping Techniques for High-Frequency Transducers.- 3. Evaporated and Sputtered Film Transducers.- 3.1. Electroelastic Properties of Cadmium Sulfide and Zinc Oxide in the Form of Thin Films.- 3.2. Evaporation Techniques for Forming CdS Transducers.- 3.3. Sputtering Techniques for Forming ZnO Transducers.- 3.4. Other Compounds of Potential Interest for Film Transducers.- 4. Concluding Remarks.- References.
「Nielsen BookData」 より