Introduction to the mechanics of plastic forming of metals
著者
書誌事項
Introduction to the mechanics of plastic forming of metals
(Monographs and textbooks on mechanics of solids and fluids)(Mechanics of plastic solids, v. 3)
Sijthoff & Noordhoff International Publishers , PWN Polish Scientific Publishers, c1979
大学図書館所蔵 件 / 全16件
-
該当する所蔵館はありません
- すべての絞り込み条件を解除する
注記
Bibliography: p. [355]-362
Includes index
内容説明・目次
内容説明
The plastic forming of metals is a branch of technology, in which great progress has been achieved mainly by collecting practical data resulting from long-time experience. The contribution of theoretical analysis to this progress is not significant. The common argument was, that such an analysis is too difficult and often even impossible. However, the constantly increasing significance of coldwork processing in industrial practice and the progress in the automatic control of these processes, demanding a broad knowledge of the influence of various parameters, and also the need to improve the mechanical behaviour of coldworked elements have proved beyond doubt that better understanding of the theory of plastic forming processes is necessary. This general trend has become evident in several recent publications in recent years, even though these represent only the engineering, approximate approach to theoretical analysis. Recent significant progress in the mathematical theory of plasticity allows to build an analysis of plastic forming processes on a more sound basis. In particular there have been developed graphical methods by means of which slip-line and hodograph meshes are constructed for plane strain and axially symmetric problems. These graphical methods yield not only the required forces but also the. mode of plastic deformation, even for very complex problems. Numerical procedures also give good results if the digital computer technique is employed.
「Nielsen BookData」 より