Tooling for metal powder parts : a practical treatment on modern practice in the process planning, tool design, equipment, and operations involved in producing structural parts from metal powders

著者

• American Society of Tool and Manufacturing Engineers
• DeGroat, George H.

書誌事項

Tooling for metal powder parts : a practical treatment on modern practice in the process planning, tool design, equipment, and operations involved in producing structural parts from metal powders

by George H. De Groat. Under the direction of ASTE National Technical Publications Committee, Francis J. Sehn, chairman [and others] Frank W. Wilson, executive editor [and] Philip D. Harvey, staff editor

McGraw-Hill, 1958

1st ed

電子リソースにアクセスする 全1件

• Tooling for metal powder parts; a practical treatment on modern practice in the process planning, tool design, equipment, and operations involved in producing structural parts from metal powders, by George H. De Groat. Under the direction of ASTE National Technical Publications Committee, Francis J. Sehn, chairman [and others] Frank W. Wilson, executive editor [and] Philip D. Harvey, staff editor.

  1958

  HathiTrust

  

注記

Includes bibliography

詳細情報

• NII書誌ID(NCID): BA21451249
• LCCN: 58007415
• 出版国コード: us
• タイトル言語コード: eng
• 本文言語コード: eng
• 出版地: New York
• ページ数/冊数: 242 p.
• 大きさ: 24 cm
• 分類:
  • LCC : TS245
  • DC : 671.37*
• 件名:
  • LCSH : Powder metallurgy
  • LCSH : Power presses
  • LCSH : Dies (Metalworking)