Advances in electronic testing : challenges and methodologies
Author(s)
Bibliographic Information
Advances in electronic testing : challenges and methodologies
（Frontiers in electronic testing）
Springer, c2006
Available at / 5 libraries
-
No Libraries matched.
- Remove all filters.
Note
Includes bibliographical references and index
Description and Table of Contents
Description
This is a new type of edited volume in the Frontiers in Electronic Testing book series devoted to recent advances in electronic circuits testing. The book is a comprehensive elaboration on important topics which capture major research and development efforts today. "Hot" topics of current interest to test technology community have been selected, and the authors are key contributors in the corresponding topics.
Table of Contents
Foreword
by Vishwani D. Agrawal Preface
by Dimitris Gizopoulos Contributing Authors Dedication Chapter 1-Defect-Oriented Testing
by Robert C. Aitken 1.1 History of Defect-Oriented Testing 1.2 Classic Defect Mechanisms 1.3 Defect Mechanisms in Advanced Technologies 1.4 Defects and Faults 1.5 Defect-Oriented Test Types 1.6 Experimental Results 1.7 Future Trends and Conclusions Acknowledgments References Chapter 2-Failure Mechanisms and Testing in Nanometer Technologies
by Jaume Segura, Charles Hawkins and Jerry Soden 2.1 Scaling CMOS Technology 2.2 Failure Modes in Nanometer Technologies 2.3 Test Methods for Nanometer ICs 2.4 Conclusion References Chapter 3-Silicon Debug
by Doug Josephson and Bob Gottlieb 3.1 Introduction 3.2 Silicon Debug History 3.3 Silicon Debug Process 3.4 Debug Flow 3.5 Circuit Failures 3.6 A Case Study in Silicon Debug 3.7 Future Challenges for Silicon Debug 3.8 Conclusion Acknowledgements References Chapter 4-Delay Testing
by Adam Cron 4.1 Introduction 4.2 Delay Test Basics 4.3 Test Application 4.4 Delay Test Details 4.5 Vector Generation 4.6 Chip Design Constructs 4.7 ATE Requirements 4.8 Conclusions: Tests vs. Defects Acknowledgements References Chapter 5-High-Speed Digital Test Interfaces
by Wolfgang Maichen 5.1 New Concepts 5.2 Technology and Design Techniques 5.3 Characterization and Modeling 5.4 Outlook References Chapter 6-DFT-Oriented, Low-Cost Testers
by Al Crouch and GeirEide 6.1 Introduction 6.2 Test Cost - the Chicken and the Low Cost Tester 6.3 Tester Use Models 6.4 Why and When is DFT Low Cost? 6.5 What does Low Cost have to do with the Tester? 6.6 Life, the Universe, and Everything References Recommended Reading Chapter 7-Embedded Cores and System-on-Chip Testing
by Rubin Parekhji 7.1 Embedded Cores and SOCs 7.2 Design and Test Paradigm with Cores and SOCs 7.3 DFT for Embedded Cores and SOCs 7.4 Test Access Mechanisms 7.5 ATPG for Embedded Cores and SOCs 7.6 SOC Test Modes 7.7 Design for At-speed Testing 7.8 Design for Memory and Logic BIST 7.9 Conclusion Acknowledgements References Chapter 8-Embedded Memory Testing
by R. Dean Adams 8.1 Introduction 8.2 The Memory Design Under Test 8.3 Memory Faults 8.4 Memory Test Patterns 8.5 Self Test 8.6 Advanced Memories & Technologies 8.7 Conclusions References Chapter 9-Mixed-Signal Testing and DfT
by Stephen Sunter 9.1 A Brief History 9.2 The State of the Art 9.3 Advances in the Last 10 Years 9.4 Emerging Techniques and Directions 9.5 EDA Tools for Mixed-Signal Testing 9.6 Future Directions References Chapter 10-RF Testing
by Randy Wolf, Mustapha Slamani, John Ferrario and Jayendra Bhagat 10.1 Introduction 10.2 Testing RF ICs 10.3 RF Test Cost Reduction Factors 10.4 Test Hardware 10.5 Hardware Development Process 10.6 High Frequency Simulation Tools 10.7 Device Under Test Interface 10.8 Conclusions Acknowledgements References Chapter 11-Loaded
by "Nielsen BookData"